We design Printed Circuit Boards, either from a schematic you provide us, or as part of a complete product. With over 24 years of designing boards and electronic design knowledge, you get the best possible layout to maximize real-estate and minimize assembly headaches. Using OrCAD Layout v9.1, our designs are completed on time and with the lowest possible cost. Our on-staff Electronic Engineers lay out each board, so the proper care is taken regarding noisy areas, decoupling capacitors, hot components, and ease of manufacturing and pick/place equipment.
We offer: 
 1 to 16 layers, all technologies (BGA, QFP, TSSOP SOT)
 Mixed through-hole and surface mount components, single or both sides.
 Gerber output is easily e-mailed to you or to PCB fabrication house.
 Fine line boards, 5 mil tracks and isolation
 Low-impedance power and ground traces and planes
 Safety adherence to UL, CSA, FCC part 68 specs
 Each layer output in format of your choice, any scale.
 Gerber file conversion and editing of your board.
 Panelizing and reverse engineering.
 Established long-term relationships with PC houses give fast turnarounds.
We use and recommend Advanced Circuits


Contact UsContact Us                Mechanical DesignNext                     KRS Industries HomeHome




© Copyright 2005 KRS Industries, Inc. All Rights Reserved.


South Florida USA